Sony SRW-9000 Operation Manual page 22

Name
PLAY button and indicator Starts playback. (The indicator
22 Locations and Functions of Parts
Pressed alone
lights during playback.) To start
recording, press this button with
the REC button held down.
Pressed with FUNC button
Pressed with tape transport stopped:
Searches for the recording end point and
then stops. When SYSTEM >SERVO
>EOS MODE in the VTR menu is set to
"NORM" (factory default setting),
rewinds for about five seconds and then
plays for about 10 seconds. If the
recording end point is located in that
section, playback stops at that point and
the unit enters recording pause mode. If
the recording end point is not located in
that section, playback continues for
about 10 seconds and then stops. When
SYSTEM >SERVO >EOS MODE in the
VTR menu is set to "LONG", the 10-
second search time limit described above
does not apply. Once playback starts, the
search continues until the recording end
point is found.
For details, see "Continuous recording
in other cases" (page 83).
Pressed with recording paused: Plays back
the most recently recorded material, and
then returns to recording pause mode
(recording review). When SYSTEM
>SERVO >REC REVIEW in the VTR
menu is set to "NORM" (factory default
setting), one press of this button rewinds
the tape about 3 seconds and then starts
playback. You can keep the PLAY button
pressed together with the FUNC button
to rewind the tape as long as the buttons
are held down (up to a maximum of 10
seconds), and then start playback.
Recording review allows you to check
whether the material was recorded
correctly. When SYSTEM >SERVO
>REC REVIEW is set to "ALL", one
press of this button rewinds up to the
beginning of the most recently recorded
cut and then starts playback.
Note
Recording review is available when recording
is paused after recording at least three
seconds.