Sony SRW-9000 Operation Manual page 131

Item
REGENE SOURCE
RUN MODE
TCG SET (MAIN)
Timecode generator
settings for the main
timecode
OTHERS (MAIN)
Other settings related to
main timecode
Settings
Selects the timecode to be regenerated by the internal
timecode generator.
INT L [Internal LTC]: Timecode recorded in the
EXT L [External LTC]: Timecode input to the TC IN
AUX L [AUX LTC]: LTC time data of the multiplexed
AUX V [AUX VITC]: VITC time data of the multiplexed
Selects the timecode generator run mode.
F RUN [Free Run]: Timecode advances without pause
R RUN [Rec Run]: Timecode advances only during
DF/NDF Selects the frame count mode.
(Valid only when the DF [Drop Frm]: Drop-frame mode
frame frequency of NDF [Non Drop Frm]: Non-drop frame mode
this system is 29.97
Note
Hz)
These settings are valid when the TCG MODE item is set to
PRST.
UBG SOURCE Selects the source timecode of user bits.
TCG [TCG Source]: The same source as the source of
INT [Internal]: Timecode generated by the timecode
12H/24H Selects the CTL display mode.
12H [+/–12H]: 12-hour display mode
24H [24H]: 24-hour display mode
Note
When +/–12H display is selected, the tens digit of the hours
value is dropped for values less than 10.
TC OUT Selects the timecode output from the TC OUT connector.
AUTO [Auto]: During playback, timecode read by the
TCG [TCG]: Timecode generated by the timecode
THRU [Through]: Through output of timecode input to
longitudinal direction on the tape
connector
signal input to the AUX IN connector (when the
optional HKSR-9001 is installed)
signal input to the AUX IN connector (when the
optional HKSR-9001 is installed)
from the time that the system is powered on.
recording.
the internal timecode generator
generator. Arbitrary user bits settings (see page 81)
are possible, regardless of the TCG setting.
internal timecode reader. During recording (including
E-E mode), timecode generated by the timecode
generator is output.
generator is output.
the TC IN connector
VTR Menu List 131