Attaching The Control Panel - Sony SRW-9000 Operation Manual

Attaching the Control
Panel
The supplied control panel is used for tape and
VTR menu operations. You can attach it to the top
panel of this unit.
1
Place the control panel on the top panel
of this unit, and slide it as shown in the
figure.
2
Connect the cable of the control panel to
the CTRL (VTR) connector, and then
fit the cable into the groove and cable
clamp on the top panel of the unit.
CTRL (VTR)
connector
Align the red mark on the cable plug
with the red mark on the CTRL (VTR)
connector (at the white dot).
To detach the control panel
Hold down the lock release button and detach the
control panel by sliding it out.
Lock release button
To use the extension cable
1
Insert the belt bracket into hole [A] or
[B] of the cable holder (supplied).
Cable clamp
2
Detach the control panel.
3
Remove the two cable holder
attachment screws.
4
Attach the cable holder, using the
attachment screws removed in step 2.
Belt bracket
Holder attachment screws

Attaching the Control Panel

35