File Operations; Using A "Memory Stick - Sony SRW-9000 Operation Manual

File Operations

Using a "Memory Stick"

You can use "Memory Stick PRO" media with
the camera module of the unit. "Memory Stick
PRO Duo" can also be used without using a
Memory Stick Duo adaptor.
Unit operations have been checked using
"Memory Stick PRO" media up to 8GB.
Operations checked with:
MSH-128
MSX-512S
MSX-M2GS
MSX-M4GS
MSX-M8GS
For details on "Memory Stick" media, see "About a
"Memory Stick"" (page 162).
Inserting a "Memory Stick"
Insert a "Memory Stick" with the label side up
into the "Memory Stick" slot until it clicks and
the access lamp lights in red.
When the "Memory Stick" is properly set, the
lamp lights in green.
Access lamp
Note
If it does not fit into the slot properly or if there is some
resistance when you insert it, the "Memory Stick" may
be turned around or upside-down. Do not force the
"Memory Stick" into the slot. Confirm the direction of
the notch and arrow on the "Memory Stick" before
inserting the "Memory Stick," and then try inserting it
again.
146 File Operations
Removing a "Memory Stick"
Confirm that the access lamp is not lit in red, then
lightly push in the "Memory Stick" to release the
lock.
If the access lamp is lit in red, data is being read from or
written to the "Memory Stick" At this time, do not shake
the product or subject it to shock. Do not turn off the
power to the product or remove the "Memory Stick."
Doing so may damage the data.
Protecting saved data
To prevent accidental erasure of important setup
data, use the LOCK switch on the "Memory
Stick."
Slide the switch right to the write protect position.
This ensures that you cannot inadvertently
overwrite data on the "Memory Stick."
The "Memory Stick Pro Duo" does not have a LOCK
switch. When using "Memory Stick Pro Duo" media, be
careful not to inadvertently overwrite or erase your data.
To format a "Memory Stick"
Use the <FILE PRESET 1> page of the FILE
menu.
1
Label side
"Memory Stick"
2
3
Note
LOCK switch
Note
Insert a "Memory Stick" you wish to
format into the "Memory Stick" slot of
the unit.
Display the <FILE PRESET 1> page of
the FILE menu.
Move the pointer to M.S. FORMAT
and press the MENU SEL/ENTER dial.