Character Data On And Off; Assigning Functions To Assignable Buttons/Switch - Sony SRW-9000 Operation Manual

• If the internal temperature rises so high that the TEMP
WARNING/FAN MAX message appears, the fan
mode changes automatically to MAX. After the
temperature has dropped sufficiently and the message
has disappeared, restore the original mode manually.
• When the video format is 50P or 59.94P, the fans are
controlled as in AUTO1 mode, even when AUTO2 or
MIN mode is selected, so that the higher power
consumption does not lead to higher internal
temperatures. Also, the fans do not operate more
quietly during recording.
To change the fan mode from a menu
You can also change the fan mode by using the
<OTHERS 1> page of the Camera >USER
(MAINTENANCE) menu (see page 117).

Character Data On and Off

You can enable and disable the superimposition
of character data onto the camera picture for
selected output destinations.
Character data page
Superimposition of character data can be turned
ON or OFF for each of the following destinations
individually.
VF
The viewfinder connected to the VF connector
(default ON)
HDY
A monitor connected to the TEST OUT or
REMOTE connector. This setting is enabled
when TEST[SIG] or RM[SIG] has been set to
HD-Y in the <MONITOR OUTPUT> page of the
Camera >USER (OPERATION) menu (default
ON).
MON
A monitor connected to the HD SDI MON1 or
HD SDI MON2 connector (default ON)
VBS
A monitor connected to the TEST OUT or
REMOTE connector (default ON)
48 Basic Settings with the Subdisplay
Assigning Functions to
Assignable Buttons/Switch
You can assign functions to the following
buttons/switch: assignable buttons 1 to 3 and 5 to
8 on the right-side panel of the main unit and the
AP-1 (optional); the 4 side (top) of the 4/AUTO
BLK BAL switch (called "switch 4" below) and
assignable buttons N and C.
The following functions are assigned when the
unit is shipped from the factory.
Switch Function
1 OFF (no function)
2 OFF (no function)
3 OFF (no function)
4 OFF (no function)
5 STOP
6 PLAY
7 REW
8 F.FWD
N OFF (no function)
C OFF (no function)
Functions that can be assigned to assignable
buttons 1 to 3, N, and C
Menu indication Function
REC REVIEW With REC REVIEW set to
NORM, the last part of the
recorded tape is normally
rewound for 3 seconds
(maximum: 10 seconds) then
played back. With REC
REVIEW set to ALL, the tape
is rewound to the recording
start position then played
back.
PB(VF/VBS) The video signals being
played back are output to the
viewfinder.
a) On/Off of the fixed ITU-R709
MLUT
gamma of the viewfinder and
the monitor
FAN MODE Switching of the fan mode
VTR SAVE Switching of the VTR power
supply mode (SAVE, STBY)
OFF None
a) When using the RGB 4:4:4 format with the optional
HKSR-9003 installed