Setting The Video Format In The Vtr Menu - Sony SRW-9000 Operation Manual

<OUTPUT FORMAT> page
CURRENT
Display the current format.
SCAN
Select the scan mode: PROGRESSIVE or
INTERLACE.
FRAME
Select the frame rate. When you select
INTERLACE for the scan mode, select 29.97 to
specify 59.94I or select 25 to specify 50I.
SIGNAL
Select the signal format.
The compression ratio of 4:4:4 HQ is 1/2 of
4:4:4SQ.
The 4:4:4 RGB format can be selected when the
HKSR-9003 is installed.
When the settings are completed, move the
pointer to SET FORMAT and press the MENU
SEL/ENTER dial.
The format is changed, and the new format is
displayed on the CURRENT line.
The message "UNSUPPORTED FORMAT"
appears for three seconds if the settings change is
rejected.
Note
If you select an invalid format combination (e.g., 60P
and 4:4:4), SET FORMAT appears in parentheses, and
the format cannot be changed.
Setting the Video Format in the
VTR Menu
Use FORMAT or OTHERS in the SYSTEM
Setup menu to select the system signal format.
Notes
• The tape formats supported by this unit differ from
those supported by the SRW-5000/5500. Depending
on the format, the SRW-5000/5500 may be unable to
72 Detailed Video Format Settings
play tapes recorded by this unit. Also, the SRW-5000/
5500 supports some frame frequencies that are not
supported by this unit.
Before selecting the tape format, be sure to read
"About Recording/Playback Formats" (page 164).
• If a cassette is loaded in the unit, be sure to eject it
before starting the following procedure.
For details on menu operations, see "VTR Menu
Operations" (page 128).
To set with FORMAT
1
Press the menu selection button
"SYSTEM" on the control panel.
The SYSTEM Setup menu appears.
2
Turn the SELECT/ENTER dial to
move the cursor to FORMAT, and then
press the dial.
A submenu window appears.
3
Turn the SELECT/ENTER dial to
select LINE in the submenu window.
A setting window appears.
Submenu window