Audition - Solid State Logic AWS 900+ Owner's Manual

Timecode/Bars & Beats/Samples Display
The on-screen time readout can be assigned to display either Timecode (SMPTE/EBU), Feet/Frames, Bars/Beats
or samples. This display will follow the setting selection made within your DAW. Please refer to your DAW manual
for further details.
DAW Status Display
To the left of the timecode display is the DAW status display. This shows the following flags:
Solo
Loop
QPunch
Pre
Post
Solo

Audition

Plug-In Display Modes
There are three display modes, Insert, Parameter and Assign, which are selected with the ASSIGN and
INSERT/PARAM buttons below the D-Pots.
Viewing Current Inserts (Insert Mode)
Press the INSERT/PARAM button till the INSERT/PARAM box reads INSERT; the plug-in editor is in Insert mode.
In this mode the four D-Pots represent four insert points on the selected channel. The currently assigned plug-ins
are displayed above each D-Pot. The name of the currently active plug-in will flash.
Additional insert points can be displayed using the paging buttons.
The four D-Pot push switches can be used to select an insert slot for editing or for plug-in assignment - see below.
Assigning a Plug-In or Hardware I/O Insert (Assign Mode)
Note: Some DAW applications will not allow assignments to be made during playback, or recording.
To Assign a Plug-in to a Channel Insert Point:
1. Press the ASSIGN soft button to enter assign mode; the on-screen box flashes to confirm this.
2. Press the D-Pot corresponding to the insert slot which you wish to route to a plug-in (use the paging buttons if
necessary) then use the D-Pot to scroll through a list of plug-ins and I/O slots. The names that are displayed
are derived from the DAW.
3. To confirm the assignment either:
a. Press the ASSIGN button a second time. This will exit INSERT mode and switch the Plug-In Editor to
PARAMETER mode for editing of the last selected insert.
b. Press the D-Pot used to make the assignment. This will confirm the assignment and leave you in Assign
mode so you can make further assignments.
Assigning the Same Plug-in to All Channels
Follow steps 1 and 2 above to select a plug-in, then hold down the OPTION button before pressing the D-Pot switch
to assign a plug-in to all channels.
Assigning The Same Plug-in to Selected Channels
To assign a plug-in to selected channels select SEL mode on the Master Control Panel then choose the channels
you wish to assign to by holding down SHIFT and pressing the channel SEL keys.
Follow steps 1 and 2 above to select a plug-in, then hold down OPTION + SHIFT before pressing the D-Pot switch
to assign the plug-in to the selected channels.
DAW has a Solo active
DAW has Loop enabled
DAW has QuickPunch selected
DAW transport has pre-roll enabled
DAW transport has post-roll enabled
DAW has a Solo active
DAW is in Audition mode. This is displayed in place of the Pre and Post flags
AWS 900+ Owner's Manual
Plug-In Editor
5 - 1 7