Figure 50: Securing Clip Nuts And The Mount Plates Onto The Rack - Mellanox Technologies Grid Director 4036 Installation Manual

Important: Make sure that you install the mount holders with the hook facing out, as
shown below.
4. Go to the rear of the rack:
1. Place two clip nuts on each side of the desired U level of the rack rails.
2. Secure the mount plates at the rear side of the rack rail (into the clip nuts) using two
screws.
Note: Rack clip nuts and screws are not provided by Mellanox.

Figure 50: Securing clip nuts and the mount plates onto the rack

62
Troubleshooting