Option 1; Figure 9: 4036E - Option 1 Rack Mount Assembly - Mellanox Technologies Grid Director 4036E Installation Manual

High-bandwidth, low-latency scalable grid director

Table of Contents

Hardware Installation

6.6.2

Option 1

This option describes how to assemble and mount the rail and install the switch where the front

of the switch faces the front of the rack. The front of the switch is recessed by 5 inches from the

vertical rail of the rack to allow connecting the power cords from the front side of the rack.

Figure 9: 4036E – Option 1 Rack Mount Assembly

NOTE: Mellanox does not provide standard rack clip nuts and rack screws.



To mount the 4036E in a rack using Option 1:

1. Put the chassis on a flat surface.

2. Mount the long bracket at the front of the chassis using three 8-32x1/4" pan head Philips

screws.

Table of Contents

Show Quick Links

Table of Contents