Figure 41: Replacing The Power Supply - Mellanox Technologies Grid Director 4036 Installation Manual

Grid Director 4036/2036 Installation Manual
When removing a power supply from the chassis, the other supply can power the entire
chassis.

Figure 41: Replacing the Power Supply


To replace a hot-swappable power supply module
1. Release the captive fasteners at each side of the power supply and gently remove the power
supply from its bay.
2. Position the rear of the new power supply in the bay.
3. Holding the power supply level, slide it into the slot until it meets resistance at the chassis
connector. It should slide smoothly and easily.
4. Push the module further until it is completely seated.
5. Use the captive fasteners at each side of the power supply to secure it in place.
NOTE: Power supplies can be replaced while the power is ON. However, it is
recommended to turn the power OFF before replacing the power supply.
Chapter 6
49