Figure 29: Mounting The Short Bracket; Figure 30: Mounting The Long Bracket - Mellanox Technologies Grid Director 4036 Installation Manual

Grid Director 4036/2036 Installation Manual
On each side of the chassis, mount the short brackets on the rear side of the switch
(InfiniBand port side) using three 8-32x1/4" pan head Philips screws, as shown on the
picture.

Figure 29: Mounting the short bracket

2. Mount the long bracket at the front of the chassis using two 8-32x1/4" pan head Philips
screws. Use the long bracket middle row orifices and the holes of top row on the rail.
Important: Left and right long brackets are different. Make sure that you are using the
correct bracket. The mounting ear at the end of the bracket should face out.
At this stage, do not fully tighten the screws.

Figure 30: Mounting the long bracket

3. Position the mounting bar and adjust it according to the rack measurements you made while
Measuring the Distance between Mounting Rails (on page 33).
43