Danfoss FC 100 Series Operating Instructions Manual page 43

Electrical Installation
Illustration 4.40:
Step 6: The speed of the motor can be seen in the LCP. It
can be adjusted by pushing the up
buttons.
Illustration 4.41:
Step 7: To move the cursor, use the left ◄ and right ►
arrow buttons. This enables changing the speed in larger
increments.
®
VLT HVAC Drive Operating Instructions
▲ ▼
and down arrow
Remove mains power from the frequency converter
before changing motor wires.
®
MG.11.AD.02 - VLT is a registered Danfoss trademark
Illustration 4.42:
Step 8: Press the [Off] button to stop the motor again.
Illustration 4.43:
Step 9: Change two motor wires if the desired rotation of
direction is not achieved.
4 4
43