Water Pump Inspection; Water Pump Installation - Suzuki Swift User Manual

WATER PUMP
1) Disconnect negative cable at battery.
2) Drain cooling system.
3) Remove timing belt and tensioner according to procedure de-
scribed in "TIMING BELT AND TENSIONER" of Section 6A or
6A1.
4) Remove water pump belt adjusting arm.
5) Remove water pump assembly (1).
INSPECTION
NOTE:
Do not disassemble water pump.
If any repair is required on pump, replace it as assembly.
Rotate water pump by hand to check for smooth operation.
If pump does not rotate smoothly or makes abnormal noise, replace
it.
INSTALLATION
1) Install new pump gasket to cylinder block.
2) Install water pump to cylinder block.
Tightening Torque
.
(a): 12 N m (1.2 kg-m, 9.0 lb-ft)
3) After installing water pump, install rubber seal (1) between water
pump and oil pump, and another between water pump and cylin-
der head.
4) Install timing belt tensioner, timing belt and timing belt outside
covers according to procedure described in "TIMING BELT AND
TENSIONER" of Section 6A or 6A1.
NOTE:
D Special care must be used when installing belt tensioner
and timing belt.
D Torque each bolt and nut to specification.
D Before installing outside covers, check to make sure that
cover seal is fitted in groove of each cover properly.
ENGINE COOLING 6B-9