6A1-40 ENGINE MECHANICAL (G13B, 1-CAM 16-VALVES ENGINE)
2
10) Using special tool, tighten pulley bolt to specified torque.
Tightening Torque
(a): 60 N
Special Tool
(A): 09917-68221
11) Install belt tensioner, timing belt, outside cover, crankshaft
pulley and water pump belt as previously outlined.
12) After applying sealant to part "A" as shown in figure, install
CMP sensor case (2) (Distributorless ignition coil case) to cyl-
inder head and tighten its fixing bolts to specified torque.
"A" Sealant: 99000-31110
Tightening Torque
(a): 11 N
1. O-ring
13) Adjust valve clearance as previously outlined.
14) Install cylinder head cover and air cleaner outlet hose.
15) Check to ensure that the following parts are back in place:
D Ignition coil assemblies
D High tension cords
D CMP sensor coupler
D Couplers to ignition coil assembly
D Other removed parts which have not been reinstalled
16) Connect negative cable at battery.
17) Confirm that ignition timing is within specification referring to
Section 6F.
.
m (6.0 kg-m, 43.5 lb-ft)
.
m (1.1 kg-m, 8.0 lb-ft)