Keyless Entry System (If Equipped) Transmitter; Replacement Of The Battery; Receiver Inspection - Suzuki Swift User Manual

8-4 BODY ELECTRICAL SYSTEM
1. To power door lock controller (Unlock)
2. To power door lock controller (Lock)
3. To IG switch
5. To door switch
6. To GND
8. To battery
KEYLESS ENTRY SYSTEM (IF EQUIPPED)
TRANSMITTER

REPLACEMENT OF THE BATTERY

If the transmitter becomes unreliable, replace the battery.
As the battery power is consumed, the operation distance will be
shorter.
1) Put the edge of a coin or a flat blade screw driver in the slot of
the transmitter and pry it open.
2) Replace the battery (lithium disc-type CR2025 or equivalent) so
its (+) terminal faces the "+" mark of the transmitter.
CAUTION:
Use care not to allow grease or dirt to be attached on the
printed circuit board and the battery.
3) Close the transmitter firmly.
4) Make sure the door locks can be operated with the transmitter.
NOTE:
D To prevent theft, be sure to break the transmitter before
discarding it.
D Dispose of the used battery properly according to appli-
cable rules or regulations. Do not dispose of lithium bat-
teries with ordinary household trash.
1. Slot
RECEIVER
INSPECTION
Using a tester, check for continuity and voltage between each termi-
nal of the connector connected to the receiver and the body ground
at the following condition.
Terminal
1
2
3
5
6
8
Check for Condition
Unlock the driver's seat
Continuity side door by using the
key.
Lock the driver's seat side
Continuity
door by using the key.
Insert the ignition key and
Voltage turn ON the ignition
switch.
Open any one of all
Voltage
closed doors.
Continuity Anytime
Voltage Anytime
Standard
value
No continuity
! Continuity
No continuity
! Continuity
0 V ! 10 – 14 V
10 – 14 V ! 0 V
Continuity
10 – 14 V