Diagnostic Trouble Code (Dtc) Table; Fail-Safe Table - Suzuki Swift User Manual

DIAGNOSTIC TROUBLE CODE (DTC) TABLE

DTC NO. DETECTING ITEM
Transmission range sensor
P0705 P0705
circuit malfunction
Output speed sensor
P0720
circuit malfunction
Shift solenoid-A
P0751
performance or stuck off
Shift solenoid-B
P0756
performance or stuck off
P0753 Shift solenoid-A electrical
P0758 Shift solenoid-B electrical

FAIL-SAFE TABLE

DTC No. DETECTED ITEM
Transmission range sensor
(switch) circuit malfunction
P0705
Output speed sensor (A/T
P0720
VSS) circuit malfunction
P0753 Shift solenoid-A electrical
P0758 Shift solenoid-B electrical
AUTOMATIC TRANSMISSION (3 A / T) (VEHICLE WITH WU-TWC) 7B-17
(DTC will set when detecting:)
g No signal or multiple signals inputted with shifted in g
"D" range.
No signal inputted while running vehicle with "D" or
"2" range.
While running in "D" range, engine speed as
com ared to vehicle s eed higher or lower than compared to vehicle speed higher or lower than
specified value
Output command from PCM and output voltage do not
agree. (Solenoid circuit shorted to ground or open)
No signal
inputted
Multiple
signal
inputted
Gear is held at 3rd gear when in "D" range and at 2nd gear when
in "2" range.
When short circuit is detected, PCM
does not output ON command to shift
solenoid until vehicle stops and selector
lever is shifted to "P" or "N" range.
DETECTING CONDITION
g
FAIL-SAFE OPERATION
PCM controls solenoids on "L" range base.
PCM controls solenoids according to following priority
order. L > R > D > 2 > N > P
MIL
1 driving g
cycle
1 driving
cycle
2 driving g
cycles
g 1 driving g
cycle
Gear is held at 3rd gear
when in "D" range.
Gear is not shifted to 1st
gear when in "D" range
or in "2" range.