Suzuki Swift User Manual page 442

6E2-14 ENGINE AND EMISSION CONTROL SYSTEM (SFI FOR G13)
IDLE SPEED/IDLE AIR CONTROL (IAC) DUTY
INSPECTION
Before idle speed/IAC duty check, make sure of the following.
D Lead wires and hoses of Electronic Fuel Injection and engine
emission control systems are connected securely.
D Accelerator cable has some play, that is, it is not tight.
D Valve lash is checked and adjusted according to maintenance
schedule.
D Ignition timing is within specification.
D All accessories (wipers, heater, lights, A/C, etc.) are out of ser-
vice.
D Air cleaner has been properly installed and is in good condition.
D No abnormal air inhaling from air intake system.
After above items are all confirmed, check idle speed and IAC duty
as follows.
NOTE:
Before starting engine, place transmission gear shift lever in
"Neutral" (shift selector lever to "P" range for A/T vehicle),
and set parking brake and block drive wheels.
1) Connect SUZUKI scan tool (1) to DLC with ignition switch OFF,
if it is available.
2) Warm up engine to normal operating temperature.
3) Check engine idle speed and "IAC duty" as follow:
Select "Data List" mode on scan tool to check "IAC duty" and en-
gine speed.
Special Tool
(A): 09931-76011 (SUZUKI scan tool)
(B): Mass storage cartridge
(C): 09931-76030 (16/14 pin DLC cable)
If duty and/or idle speed is out of specifications, inspect idle air
control system referring to Diagnostic Flow Table B-4 IDLE AIR
CONTROL SYSTEM CHECK in Section 6.
ENGINE IDLE SPEED AND IAC DUTY
M/T vehicle
750 ± 50 r/min (rpm) 750 ± 50 r/min (rpm)
A/T vehicle
at P/N range
NOTE:
Duty values with (*) are applicable to vehicle used at high
altitude (higher than 2,000 m or 6,560 ft).
4) Check that 875 ± 50 r/min. idle speed is obtained with lighting
switch ON and heater blower switch in 2 – 4 position.
If not, check "Electric load (+)" circuit and "Heater blower switch
signal" circuit referring to "ELECTRONIC CONTROL SYSTEM"
in this section and idle air control system.
5) Check that specified engine idle speed is obtained with A/C ON
if vehicle is equipped with A/C.
If not, check A/C ON signal circuit.
A/C OFF
8 – 25 or *8 – 35%
A/C ON
875 ± 50 r/min 875 ± 50 r/min
(rpm)