Suzuki Swift User Manual page 9

CAUTION:
D Even when the accident was light enough not to cause air
bags to deploy, be sure to inspect system parts and other
related parts according to instructions under "Repair and
Inspection Required after an Accident" in Section 9J.
D When servicing parts other than air bag system, if shocks
may be applied to air bag system component parts, re-
move those parts beforehand.
D When handling the air bag (inflator) modules (driver and
passenger) or SDM, be careful not to drop it or apply an im-
pact to it. If an excessive impact was applied (e.g.,
dropped from a height of 91.4 cm (3 feet) or more), never
attempt disassembly or repair but replace it with a new
one.
D When grease, cleaning agent, oil, water, etc. has got onto
air bag (inflator) modules (driver and passenger), wipe off
immediately with a dry cloth.
D Air bag wire harness can be identified easily as it is cov-
ered with a yellow protection tube. Be very careful when
handling it.
D When an open in air bag wire harness, damaged wire har-
ness, connector or terminal is found, replace wire har-
ness, connectors and terminals as an assembly.
D Do not apply power to the air bag system unless all com-
ponents are connected or a diagnostic chart requests it,
as this will set a diagnostic trouble code.
D Never use air bag system component parts from another
vehicle.
D When using electric welding, be sure to temporarily dis-
able air bag system referring to "Disabling Air Bag Sys-
tem" under "Service Precaution" in Section 9J.
D Never expose air bag system component parts directly to
hot air (drying or baking the vehicle after painting) or
flames.
D WARNING /CAUTION labels are attached on each part of
air bag system components. Be sure to follow the instruc-
tions.
D After vehicle is completely repaired, perform "Air Bag
Diagnostic System Check" described in "Diagnosis" in
Section 9J.
GENERAL INFORMATION 0A-5