Automatic Transmission Diagnostic Flow Table - Suzuki Swift User Manual

AUTOMATIC TRANSMISSION DIAGNOSTIC FLOW TABLE

Refer to the following pages for the details of each step.
STEP
1 Customer Complaint Analysis
1) Perform customer complaint analysis referring to the next
page.
Was customer complaint analysis performed according to
instruction on the next page?
2 Diagnostic Trouble Code (DTC) and Freeze Frame Data
Check, Record and Clearance
1) Check for DTC (including pending DTC) referring to the
next page.
Is there any DTC(s)?
3 Visual Inspection
1) Perform visual inspection referring to the next page.
Is there any faulty condition?
4 Visual Inspection
1) Perform visual inspection referring to the next page.
Is there any faulty condition?
5 Trouble Symptom Confirmation
1) Confirm trouble symptom referring to the next page.
Is trouble symptom identified?
6 Rechecking and Record of DTC/Freeze Frame Data
1) Recheck for DTC and freeze frame data referring
to "DTC CHECK" in this section.
Is there any DTC(s)?
7 Rechecking and Record of DTC/Freeze Frame Data
1) Recheck for DTC and freeze frame data referring to "DTC
CHECK" in this section.
Is there any DTC(s)?
8 Automatic Transmission Basic Inspection and
Symptoms-to-Inspection Table
1) Check and repair according to "A/T BASIC CHECK" and
"SYMPTOM-TO-INSPECTION TABLE" in this section.
Are check and repair complete?
9 Trouble shooting for DTC
1) Check and repair according to applicable DTC flow Table.
Are check and repair complete?
10 Check for Intermittent Problems
1) Check for intermittent problems referring to the next page.
Is there any faulty condition?
11 Final Confirmation Test
1) Clear DTC if any.
2) Perform final confirmation test referring to the next page.
Is there any problem symptom, DTC or abnormal condition?
AUTOMATIC TRANSMISSION (3 A / T) (VEHICLE WITH WU-TWC) 7B-13
ACTION YES
Go to Step 2. Perform
customer
complaint
analysis.
1) Print DTC and Go to Step 4.
freeze frame
data or write
them down
and clear
them by
referring to
"DTC CLEAR-
ANCE" in this
section.
2) Go to Step 3.
1) Repair or Go to Step 5.
replace
malfunction
part. t
Go to Step 8.
2) Go to Step
11.
Go to Step 6. Go to Step 7.
Go to Step 9. Go to Step 8.
Go to Step 9. Go to Step 10.
Go to Step 11. 1) Check and
repair
malfunction
part(s).
2) Go to Step 11.
1) Repair or Go to Step 11.
replace
malfunction
part(s).
2) Go to Step 11.
Go to Step 6. End.
NO