Suzuki Swift User Manual page 136

INSPECTION
STEP
1 Was "ENGINE DIAG. FLOW TABLE" performed?
2 Check VSS for Resistance.
1) Disconnect VSS connection with ignition switch OFF.
2) Check for proper connection to VSS at "Bl" and "P" wire
terminals.
3) If OK, then check resistance of VSS. See Fig. 1.
Resistance between terminals : 100 – 300 Ω
Resistance between terminal
and transmission
Are check result satisfactory?
3 Check Visually VSS and Counter Shaft Gear for the
Following. See Fig. 2.
D No damage
D No foreign material attached
D Correct installation
Are they in good condition?
Fig. 1 for Step 2
ENGINE GENERAL INFORMATION AND DIAGNOSIS (TBI FOR G10) 6-85
ACTION
: 1 MΩ or more
Fig. 2 for Step 3
YES
Go to Step 2. Go to "ENGINE
DIAG. FLOW
TABLE".
Go to Step 3. Replace VSS.
"BI" or "P" wire Clean, repair or
open or shorted to replace.
ground or poor
C03-2 or C03-13
connection. If
wires and
connections are
OK, intermittent
trouble or faulty
PCM. Check for
intermittent
referring to
"Intermittent and
Poor Connection"
in Section 0A.
NO