Add/Edit Static Route - ZyXEL Communications EX3510-B1 User Manual

Figure 81 Network Setting > Routing > Static Route
The following table describes the labels in this screen.
Table 39 Network Setting > Routing > Static Route
LABEL
Add New Static
Route
#
Status
Name
Destination IP
Subnet Mask/
Prefix Length
Gateway
Interface
Modify

9.2.1 Add/Edit Static Route

Use this screen to add or edit a static route. Click Add new static route in the Routing screen or the Edit
icon next to the static route you want to edit. The screen shown next appears.
Note: The Gateway IP Address must be within the range of the selected interface in Use
Interface.
Chapter 9 Routing
DESCRIPTION
Click this to configure a new static route.
This is the index number of the entry.
This field displays whether the static route is active or not. A yellow bulb signifies that this route is
active. A gray bulb signifies that this route is not active.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is always based
on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the same network
segment as the device's LAN or WAN port. The gateway helps forward packets to their
destinations.
This is the WAN interface used for this static route.
Click the Edit icon to edit the static route on the Zyxel Device.
Click the Delete icon to remove a static route from the Zyxel Device. A window displays asking
you to confirm that you want to delete the route.
EX3510-B1 User's Guide
139