Connecting Devices To The External Power Supply - Brocade Communications Systems ICX 6430 Installation Manual

3
Installing the device
5. Lock down the wire saddle hook on the EPS cord and tighten by adjusting the nut connector, as
FIGURE 50
1

Connecting devices to the external power supply

Complete the following steps to connect devices to the external power supply.
1. Connect one end of the AC cord to the AC receptacle on the device, and the other end to a
2. Connect one end of an EPS cord to the external power receptacle on the device, and the other
3. Repeat
4. Connect one end of the AC cord to the AC receptacle on the external power supply, and the
50
illustrated in Figure 50.
Adjusting the wire saddle on the EPS cord
1
Wire saddle
grounded power outlet.
end to an available receptacle on the external power supply (EPS OUT 1, EPS OUT 2, and EPS
OUT 3).
step 1 and step 2
Figure 51.
other end to a grounded power outlet.
to connect up to three devices to the external power supply. Refer to
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1002738-02