Rack Mount Installation - Brocade Communications Systems ICX 6430 Installation Manual

2
Installing the device
FIGURE 22
1. Attach the four adhesive feet to the bottom of the device. Refer to
2. Set the device on a flat desktop, table, or shelf near an AC power source. Make sure that
3. If installing a single device only, refer to
4. If installing multiple devices, attach the adhesive feet to each device.

Rack mount installation

The devices use stationary mounting when mounted in a rack.
DANGER
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.
NOTE
You need a #2 Phillips screwdriver for rack mount installation.
Complete the following steps to mount devices in rack.
1. Remove the rack mount kit from the shipping carton. The kit contains two L-shaped mounting
2. Using a Phillips screwdriver, attach the mounting brackets to the sides of the device using six
18
Attaching the adhesive feet
adequate ventilation is provided for the system. A 7.62 cm (3-inch) clearance is recommended
on each side.
device squarely on top of the one below.
brackets and six sink-head screws.
sink-head screws, as illustrated in
"Powering on the system"
Figure 23.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
Figure 22.
on page 35. Place each
53-1002738-02