Cleaning The Fiber-Optic Connectors - Brocade Communications Systems ICX 6430 Installation Manual

6
Copper or fiber-optic module replacement
1. Remove the protective covering from the fiber-optic port connectors and store the covering for
2. Gently insert the cable connector (a tab on each connector should face upward) into the
3. Observe the link and active LEDs to determine if the network connections are functioning

Cleaning the fiber-optic connectors

To avoid problems with the connection between the fiber-optic transceiver (SFP, SFP+, or
mini-GBIC) and the fiber cable connectors, Brocade strongly recommends cleaning both
connectors each time you disconnect and reconnect them. Dust can accumulate in the connectors
and cause problems, such as reducing the optic launch power.
To clean the fiber cable connectors, Brocade recommends using a fiber-optic reel-type cleaner.
When not using an SFP connector, make sure to keep the protective covering in place.
76
future use.
NOTE
Before cabling a fiber-optic transceiver, Brocade strongly recommends cleaning the cable
connectors and the port connectors. For more information, refer to
connectors" on page 76.
transceiver connector until the tabs lock into place.
properly. For more information about the LED indicators, refer to Table 15.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
"Cleaning the fiber-optic
53-1002738-02