Preparing The Installation Site; Cabling Infrastructure; Installation Location - Brocade Communications Systems ICX 6430 Installation Manual

2

Preparing the installation site

CAUTION
Ensure that the device does not overload the power circuits, wiring, and over-current protection.
To determine the possibility of overloading the supply circuits, add the ampere (amp) ratings of all
devices installed on the same circuit as the device. Compare this total with the rating limit for the
circuit. The maximum ampere ratings are usually printed on the devices near the input power
connectors.
DANGER
Disconnect the power cord from all power sources to completely remove power from the device.
DANGER
If the installation requires a different power cord than the one supplied with the device, make
sure you use a power cord displaying the mark of the safety agency that defines the regulations
for power cords in your country. The mark is your assurance that the power cord can be used
safely with the device.

Preparing the installation site

Before installing the device, plan its location and orientation relative to other devices and
equipment.

Cabling infrastructure

Ensure that the proper cabling is installed at the site.For information about supported SFP and
SFP+ transceivers and cable lengths and types, refer to the following Brocade website:

Installation location

Devices can be mounted in a standard 19-inch equipment rack or on a flat surface.
The site should meet the following requirements:
•
•
•
•
16
http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_
DS.pdf
Maintain the operating environment as specified in the section
considerations" on page 79.
Allow a minimum of 7.62 cm (3 in.) of space between the front and the back of the device and
walls or other obstructions for proper airflow.
Allow at least 7.62 cm (3 in.) of space at the front and back of the device for the twisted-pair,
fiber-optic, and power cabling.
The site should be accessible for installing, cabling and maintaining the devices.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
"Environmental
53-1002738-02