Displaying Cpu Usage; Removing Mac Address Entries - Brocade Communications Systems ICX 6430 Installation Manual

The value variable can be from 0 through 65535 seconds.

Displaying CPU usage

You can display the amount of the CPU in use. To do so, enter the show cpu command at any level
of the CLI.
Brocade# show cpu
20 percent busy, from 318 sec ago
1
5
60
300 sec avg:
Syntax: show cpu

Removing MAC address entries

You can remove the following types of learned MAC address entries from the system MAC address
table:
•
•
•
•
For example, to remove entries for the MAC address 00-00-00 in all VLANs, enter the following
command at the Privileged EXEC level of the CLI.
Brocade# clear mac-address 00-00-00
Syntax: clear mac-address mac-address | ethernet port-num | vlan number
If you enter the clear mac-address command without any parameters, the software removes all
MAC entries.
Use the mac-address variable to remove a specified MAC address from all VLANs. Specify the MAC
address in the following format: HHHH.HHHH.HHHH.
Use the ethernet port-num parameter to remove all MAC addresses for a specified Ethernet port.
Use the vlan number parameter to remove all MAC addresses for a specified VLAN.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1002738-02
sec avg: 2 percent busy
sec avg: 1 percent busy
sec avg: 1 percent busy
1 percent busy
All MAC address entries
All MAC address entries for a specified Ethernet port
All MAC address entries for a specified VLAN
A specified MAC address entry in all VLANs
Displaying CPU usage
5
71