Connecting Devices To The Redundant Power Supply - Brocade Communications Systems FWS648G-POE Hardware Installation Manual

Connecting devices to the redundant power supply

The FastIron RPS2-EIF is supported on the following devices:
•
•
The FastIron RPS12 is supported on the following devices:
•
•
To connect devices to a redundant power supply, follow these steps.
1. Connect one end of the AC cord to the AC receptacle on the device, and the other end to a
FIGURE 21
2. Connect one end of a DC cord to the redundant power receptacle on the device and the other
3. Repeat
4. Connect one end of the AC cord to the AC receptacle on the redundant power supply, and the
5. Check the LEDs on the redundant power supply to ensure proper operation. On the RPS2-EIF
Brocade FastIron WS Hardware Installation Guide
53-1002188-01
DRAFT: BROCADE CONFIDENTIAL
FastIron WS624
FastIron WS648
FastIron FWS624-POE
FastIron FWS648-POE
grounded power outlet. Refer to
Power receptacle
RPS 1
end to an available receptacle on the redundant power supply.
step 1 and step 2
Figure 22.
other end to a grounded power outlet.
and RPS12, the Power LED should light up. If the LEDs do not light, refer to
on page 53 for more information.
Installing a redundant power supply
Figure 21.
to connect up to four devices to the redundant power supply. Refer to
100-240V, 50-60Hz 10A
"Troubleshooting"
2
23