2
Installing the device
1
2
6. If installing a single device only, proceed to
Wall mount installation
NOTE
You need a #2 Phillips screwdriver, a hammer, and a drill for wall mount installation.
Mounting the device to a wall is only applicable to ICX 6430-24, ICX 6430-24P, ICX 6450-24, and
ICX 6450-24P devices. Brocade recommends that you wall mount the device with the port side
down. See
NOTE
The ICX 6430-48, ICX 6430-48P, ICX 6450-48, and ICX 6450-48P devices cannot be wall mounted.
Complete the following steps to mount the device to a wall.
1. Attach the four adhesive feet to the bottom of the device, as illustrated in
2. Using a Phillips screwdriver, attach the wall mount brackets to the sides of the device using
20
Rack-mounting screws
Cage nuts
multiple devices, mount them in the rack, one below the other.
Figure
26.
four sink-head screws, as illustrated in
"Powering on the system"
Figure
25.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
on page 35. If installing
Figure
25.
53-1002738-02