Connecting Devices To The External Power Supply - Brocade Communications Systems ICX 6430 Hardware Installation Manual

Installing the device
5. Lock down the wire saddle hook on the EPS cord and tighten by adjusting the nut connector, as illustrated in the figure below.
FIGURE 49 Adjusting the wire saddle on the EPS cord
1. Wire saddle

Connecting devices to the external power supply

Complete the following steps to connect devices to the external power supply.
1. Connect one end of the AC cord to the AC receptacle on the device, and the other end to a grounded power outlet.
2. Connect one end of an EPS cord to the external power receptacle on the device, and the other end to an available receptacle on
the external power supply (EPS OUT 1, EPS OUT 2, and EPS OUT 3).
3. Repeat Step 1 and Step 2 to connect up to three devices to the external power supply. Refer to the following figure.
62
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
Part Number: 53-1003617-03