Connecting Devices To The External Power Supply - Brocade Communications Systems ICX 6430 Hardware Installation Manual

Connecting devices to the external power supply

Connecting devices to the external power supply
Complete the following steps to connect devices to the external power supply.
1.
2.
3.
60
1 Wire saddle
FIGURE 49 Adjusting the wire saddle on the EPS cord
Connect one end of the AC cord to the AC receptacle on the device, and the other end to a
grounded power outlet.
Connect one end of an EPS cord to the external power receptacle on the device, and the other
end to an available receptacle on the external power supply (EPS OUT 1, EPS OUT 2, and EPS
OUT 3).
Repeat Step 1 and Step 2 to connect up to three devices to the external power supply. Refer to
the figure below.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1003079-01