Wall Mount Installation - Brocade Communications Systems ICX 7250 Hardware Installation Manual

FIGURE 38 Attaching the rear brackets to the front rack posts
1. Screws, 10-32 x 5/8-in., panhead Phillips

Wall mount installation

NOTE
You need a #2 Phillips screwdriver, a hammer, and a drill for wall mount installation.
Brocade recommends that you wall mount the device with the port side down.
Complete the following steps to mount the device to a wall.
DANGER
This equipment is suitable for mounting on concrete or other noncombustible surfaces only.
1. Attach the four adhesive feet to the bottom of the device.
2. Using a Phillips screwdriver, attach the wall mount brackets to the sides of the device using four #6-32 sink-head screws on
each side.
Brocade ICX 7250 Switch Hardware Installation Guide
53-1003898-02
2. Retainer nuts, 10-32
Installation
57