HYOSUNG MS3 250 Owner's Manual page 82

◉ ◉ IGNITION SYSTEM CHECK
1. Remove the spark plug and reattach it to
the spark plug lead.
2. Put the engine stop switch in the "
position and ignition switch in the "
(ON) position. While holding the spark
plug base firmly against the engine, the
front or rear brake lever is squeezed and
push the electric starter switch. If the igni-
tion system is operating properly, a blue
spark should jump across the spark plug
gap. If there is no spark, take your motor-
cycle to your Hyosung dealer.
WARNING
Performing the spark test improperly
can be hazardous.
You could get a high voltage electrical
shock or an explosion if you are not
familiar with this procedure.
Do not perform this check if you are
not familiar with the procedure.
Keep the spark plug away from the
spark plug hole during this test. Do
not this test if you have a heart condi-
tion or wear a pacemaker.
◉ ◉ ENGINE STALLING
1. Check the fuel supply in the fuel tank.
2. Check the ignition system for intermittent
spark.
3. Check the idle speed.
CAUTION
When occur any trouble, the best way
is to consult your Hyosung dealer for
repairs.
"
"
Before transporting the motorcycle, it
is necessary to empty the fuel tank
completely, making sure that it is com-
pletely dry.
During transport, the motorcycle must
be firmly secured in an upright posi-
tion to avoid fuel, oil and coolant leaks.
◉ ◉ DRAINING THE FUEL TANK
Keep the fuel tank away from fires.
Allow some time for the engine and
muffler to cool down completely.
Fuel vapours are harmful to human
health.
Ensure the area is well ventilated
before proceeding.
Do not inhale fuel vapours.
Do not smoke, nor use naked flames.
● Place the motorcycle on the center
stand on firm and level ground.
● Stop the engine and wait until it has
cooled down.
● Prepare a container large enough to
hold the fuel in the tank and place it on
the floor on the left side of the motorcy-
cle.
● Remove the fuel tank cap.
● Drain fuel using a manual pump or simi-
lar system. Do not damage the fuel
pump assembly (fuel level sensor
accommodated inside the tank).
Refit the fuel tank cap after draining all
fuel.
81
TRANSPORT
WARNING
WARNING
WARNING