HYOSUNG MS3 250 Owner's Manual page 25

⑨ ⑨
TRIP SWITCH
Use this switch to adjust the following :
Push it for
0.6 ~ 1
Odometer
seconds → Odometer
⑩ ⑩
HOUR SWITCH
Use this switch to adjust the following :
In the clock mode
●
Push it for
Clock mode
2 seconds
In the clock reset mode
●
Push it for
0.6 ~ 1
Increase the hour of clock
seconds
Clock reset mode
2 seconds
⑪ ⑪
MIN SWITCH
Use this switch to adjust the following :
In the clock mode
●
Push it for
To adjust the light of
0.6 ~ 1
speedometer display
seconds
(100%
In the clock reset mode
●
Push it for
0.6 ~ 1
Increase the minutes of clock
seconds
Adjustment
→ Trip meter
Adjustment
→ Clock reset mode
Adjustment
→ Clock mode
Adjustment
75% 50% 25% 100%)
→ → → →
Adjustment
⑫ ⑫
SPEEDOMETER
The speedometer indicates the road
speed in kilometers or miles per hour.
Obey the speed limit and traffic regu-
lation at all times.
⑬ ⑬
TACHOMETER
The tachometer indicates the engine
speed in revolutions per minutes (rpm).
Revving the engine into the red zone
can cause severe engine damage.
Never allow the engine to rev into the
red zone.
⑭ ⑭
OIL PRESSURE INDICATOR LAMP
This indicator lamp comes on when the
engine oil pressure is below the normal
operating range.
This indicator lamp should come on when
the ignition switch is "
engine is not running.
As soon as the engine starts, this lamp
should go out.
Riding the motorcycle with the oil
pressure indicator lamp lit can dam-
age the engine and transmission.
Whenever the oil pressure indicator
lamp comes up, indicating low oil
pressure, stop the engine immediately.
Check the oil level and determine if
the proper amount of oil is in the
engine.
If the lamp still does not go out, have
your authorized HYOSUNG dealer or
qualified mechanic troubleshoot your
motorcycle.
24
WARNING
CAUTION
"(ON) and the
CAUTION