HYOSUNG MS3 250 Owner's Manual page 64

WARNING
If brake pads were allowed to wear
down until uncovering the metal sub-
strate, metal-to-metal contact with the
brake disc would lead to rattle and the
brake caliper sparking ; this would
result in loss of braking and brake
disc damage, cousing a dangerous
riding conditions.
CAUTION
After replaced the front or rear brake
pads, the brake lever pull and release
several times so that it is setting at
the original place.
Then, do not ride the motorcycle untill
operating the brake fluid and becom-
ing the brake distance.
◉ ◉ BRAKE DISK INSPECTION
Check the brake disk for damage or
cracks.
◉ ◉ FRONT & REAR BRAKE FLUID
SUPPLY
1. Place the motorcycle on a level surface
and keep the handlebars straight.
2. Clean the brake fluid reservior around not
to allow dust to get inside of it.
3. Loosen the screw and open the cap.
4. Replenish with brake fluid to the upper
line.
Do not spill any brake fluid on painted
or plastic surfaces as it will damage
the surface severely.
N O T E
The recommended brake fluid
5. Fasten the cap.
● ● Don't replenish with brake fluid
over the limit line. It will leak out of
the brake fluid reservoir.
● ● Be careful not to allow dusts or
water to go inside when it is replen-
ished.
● ● Don't use the unrecommended
brake fluid.
● ● Brake fluid can damage severely
the plastics or rubbers. When it is
spilt on the parts, mop them up.
63
CAUTION
CAUTION
: DOT4