HYOSUNG MS3 250 Owner's Manual page 39

◉ ◉ TRANSMISSION OIL CHANGE
1. Start the engine to warm up the oil, this
will facilitate draining oil.
2. Hold the motorcycle vertically.
N O T E
Position the vehicle on firm and flat
ground.
3. Place a drain pan under the engine.
4. Remove the transmission oil filler cap ① .
�
�
5. Release and remove the transmission oil
6. Let all transmission oil drain out.
7. Fit and tighten the transmission oil drain
8. Fill about 360 ㎖
�
9. Install the transmission oil filler cap ① .
10. Check the transmission oil level using
11. Install the transmission oil level bolt ② .
12. Operate the engine a few minutes by
38
level bolt ② and oil drain bolt ③ .
Collect it in a drian pan with adequate
capacity.
bolt ③ .
through the transmission oil filler hole.
TRANSMISSION OIL CAPACITY
360 ㎖
CHANGE
400 ㎖
OVERHAUL
the transmission oil level bolt hole and
top up as required without exceeding
the transmission oil level bolt hole.
idling speed.
Inspect the oil leakage at the transmis-
sion oil drian bolt and oil level bolt.
of the specified of
←
←