HYOSUNG MS3 250 Owner's Manual page 28

WARNING
Do not operate for the engine stop
switch is in the " "
driving at one's pleasure.
③ ③
HAZARD WARNING SWITCH
■ "
" : All four turn signal lamp and
indicator lamp will flash simulta-
neously when the switch is turn
on.
■ "
" : The turn signal lamp and indi-
●
cator lamp go off.
Use the hazard warning switch to warn
other traffic during emergency parking or
when your motorcycle could otherwise
become a traffic hazard.
④ ④
STARTER SWITCH
Use this switch to operate the starting
motor.
CAUTION
With the engine stop switch in the
" " position and the ignition switch
in the " " " " (ON) position, push the
starter switch to start the engine after
go off the "FI" check lamp.
N O T E
If the front or rear brake lever is not
squeezed, the starting motor will not
rotate.
" " position while
Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after sev-
eral attempts, check the fuel supply
and igintion system.
(Refer for Page 80)
These motorcycles always come on
the head lamp, position lamp, meter
lamp, tail lamp and license plate lamp
when the ignition switch is turned to
the " "(ON) position.
⑤ ⑤
THROTTLE GRIP
Engine speed is controlled by position of
the throttle grip. Turn it toward you to
increase engine speed. Turn it away from
you to decrease the engine speed.
Avoid turning the throttle grip during
brakes.
27
CAUTION
CAUTION
WARNING