HYOSUNG MS3 250 Owner's Manual page 75

BATTERY
◉ ◉ INSPECTION OF BATTERY SOLU-
TION LEVEL
MF(Maintenance Free) battery of airtight
type is used for these motorcycles.
It is not necessary to inspect or supple-
ment battery fluid.
The battery is located inside the right side
front lower cover.
However, have your dealer check the
charging condition of battery periodically.
CAUTION
● ● Do not remove absolutely airtight
cover as airtight type battery.
● ● Keep after separate at the motorcy-
cle for the minimum of self electric
discharge and electric leakage
when don't use for a long time.
Remove the (-) negative terminal
when keep intact at the motorcycle.
WARNING
Never invert the battery cables.
Ensure that the ignition switch is in
position " "(OFF) before connecting
or disconnecting the battery,
otherwise some components might
damage.
◉ ◉ REMOVING THE BATTERY
N O T E
Position the motorcycle on firm and
flat ground.
1. Position the motorcycle on the center
stand.
2. Make sure that the ignition switch is in
position "
3. Remove the screw ①
② .
4. Remove the right side front lower cover
③ .
�
5. Disconnect the negative (-) battery wire
first, then disconnect the positive (+) bat-
tery wire.
6. Remove the battery.
◉ ◉ CHECK AND CLEAN OF BATTERY
TERMINAL
Clean the battery terminal when it is dusty
or rusted.
1. Set the ignition switch "
2. Remove the right side front lower cover.
3. Check that battery lead wire and terminal.
4. If necessary : disconnect the negative
(-) battery wire first, then disconnect the
74
"(OFF).
and hexagon bolt
�
�
"(OFF) position.