HYOSUNG MS3 250 Owner's Manual page 34

4. Unscrew and extract the engine oil
level gauge ① .
5. Clean the part in contact with the
engine oil with a clean cloth.
6. Reinsert the engine oil level gauge until
the threads touch filler neck, but do not
screw the engine oil level gauge in.
N O T E
Engine oil expands and oil level
increases when the engine oil is hot.
Check and adjust engine oil level
when the engine oil is not hot.
7. Draw out the engine oil level gauge
and check the engine oil level. The
level found on the engine oil level
gauge should be between "Lower limit
line" and "Upper limit line".
If the engine oil level is below the
"Lower limit line", add fresh oil into the
filler hole until the engine oil level
reaches the "Upper limit line".
Lower limit line
CAUTION
" " Fuel, Oil and Coolant" " use certainly
to recommend at the front part.
�
Upper limit line
Operating the motorcycle with an
incorrect amount of engine oil can
damage your motorcycle.
Too little or too much engine oil can
damage your engine.
Place the motorcycle on level ground.
Check the engine oil level with the
engine oil level gauge before each
use of the motorcycle. Be sure the
engine oil level is always above the
"Lower limit line" and not higher than
the "Upper limit line".
◉ ◉ ENGINE OIL AND FILTER CHANGE
Change the engine oil and filter, after first
running 1,000 km and every running 4,000
km.
The engine oil should always be changed
when the engine is hot so that the engine
oil will be drained thoroughly from the
engine. The procedure is as follows.
ENGINE OIL CAPACITY
Replace
Oil filter replace
Overhaul
In case of the engine oil pouring exces-
sively, the engine output being made
insufficient.
Be careful not to pour the engine oil
excessively.
33
CAUTION
800 ㎖
900 ㎖
1,000 ㎖
CAUTION
←
←
←