HYOSUNG MS3 250 Owner's Manual page 22

CAUTION
To adjust the light of speedometer dis-
play, push the switch ⑪ ⑪
mode) for 0.6 ~ 1 seconds while you
want to change.
[Light of speedometer display]
① ①
TURN SIGNAL INDICATOR LAMP
When the turn signals are being operated
either to the right or to the left, the indicator
will flash at the same time.
② ②
HIGH BEAM INDICATOR LAMP
The high beam indicator lamp will come
on when the head lamp high beam is turned
on.
③ ③
"FI"(Fuel Injection) CHECK LAMP
It comes on for about three seconds
whenever the ignition switch is set to
" "(ON) position with the engine stopped
as a test of injection system operation. The
check lamp must go off after three seconds.
CAUTION
If the lamp comes on during normal
engine operation, it means that the
fuel injection system is not operating
correctly. When this is the case, stop
the engine immediately and contact a
Hyosung authorised dealer.
(in the clock
100%
↓ ↓
75%
↓ ↓
50%
↓ ↓
25%
④ ④
FUEL METER
LCD(Liquid Crystal Display) type, it indi-
cates the remaining fuel amount in the fuel
tank.
The "F"(Full) mark indicates the fuel tank
is full.
The "E"(Empty) mark indicates the fuel
tank is empty or nearly so.
When the remaining fuel is approximately
1.5 ℓ , the 1st lower segment and "
mark flicker.
Fill the fuel tank before the lowest seg-
ment flickers.
The fuel tank capacity is 8.0 ℓ .
When the lowest segment flickers,
you should add fuel to the fuel tank at
the first opportunity to avoid running
out of fuel.
For checking the fuel meter, hold the
motorcycle vertically and turn the
ignition switch to the "
tion.
21
's speedometer is
CAUTION
CAUTION
"(ON) posi-
"