HYOSUNG MS3 250 Owner's Manual page 37

9. Screw on the new engine oil filter by
hand until the filter gasket contacts the
mounting surface (a small resistance will
be felt).
CAUTION
To tighten the engine oil filter proper-
ly, it is important to accurately identify
the position at which the oil filter gas-
ket first contacts the mounting sur-
face.
10. Pour fresh engine oil through the filler
hole. Approximately 900 ㎖
will be required.
N O T E
Approximately 800 ㎖ ㎖
be required when changing oil only
without replacing the oil filter.
�
11. Install the engine oil level gauge ① .
of engine oil
of engine oil will
Failure to use the correct oil can dam-
age your motorcycle.
Engine damage may occur if you use
oil that does not meet Hyosung's
specifications.
Be sure to use the oil specified in the
FUEL, OIL AND COOLANT RECOM-
MENDATION section.
12. Start the engine and allow it idle for a
few minutes. Check to see that no oil is
leaking from the oil filter and drain
plugs.
13. Check the oil level according to Oil
Level Check procedure.
Oil leaks from around the oil filter or
drain plugs indicate incorrect installa-
tion or gasket damage. If you find any
leaks or are not sure that the oil filter
has been properly tightened, have the
motorcycle inspected by your
Hyosung dealer or qualified mechanic.
36
CAUTION
CAUTION