HYOSUNG MS3 250 Owner's Manual page 71

SIDE COVER STAY
cover stay" inside the side cover.
Use the "Side cover stay" to inspect the
engine or the other parts easily.
1. Position the motorcycle on the center
stand.
2. Raise the seat.
3. Remove the two bolts ①
trunk.
�
4. Remove the two bolts ②
�
have the "Side
in the personal
of the rear carrier.
70
5. Push the side cover for the rear side.
CAUTION
Proceed with care.
Do not damage the cover, reflector
and lamp.
Handle plastic and paint-finished parts
with care to avoid scratching or
damage.
6. Disconnect the tail lamp coupler.
7. Lift the front end of the side cover and
prop it up as shown below.
Insert the crank end of the side cover stay
③
into the hole of the side cover.
CAUTION
Upon reassembly, install the bolts and
cover correctly in the appropriate
seats.
�