Preparations; Required Tools; Installation Requirements - Body Solid G9S Assembly Instructions Manual

CAUTION: To set up this unit, you will need assistance. Do not attempt assembly by yourself.
You must review and follow the instructions in this Owner's Manual. If you do not assemble and use the
EXM3700GLPS according to these guidelines, you could void the Body-Solid warranty.

Required Tools

The tools that you must obtain before assembling
the EXM3700GLPS include:
2mm Allen Key
3mm Allen Key
4mm Allen Key
5mm Allen Key
6mm Allen Key
8mm Allen Key
1/2" Open-End Wrench
9/16" Open-End Wrench
3/4" Open-End Wrench
13/16" Open-End Wrench
1/2" Box Wrench
9/16" Box Wrench
3/4" Box Wrench

Installation Requirements

Follow these installation requirements when assembling
the EXM3700GLPS:
Set up the EXM3700GLPS on a solid, flat surface. A
smooth, flat surface under the machine helps keep it
level. A level machine has fewer malfunctions.
Provide ample space around the machine. Open
space around the machine allows for easier access.
Insert all bolts in the same direction. For aesthetic
purposes, insert all bolts in the same direction
unless specified (in text or illustrations) to do otherwise.
Leave room for adjustments. Tighten fasteners such as
bolts, nuts, and screws so the unit is stable, but leave
room for adjustments. Do not fully tighten fasteners
until instructed in the assembly steps to do so.
Fill out and mail warranty card.
P r e p a r a t i o n s
CAUTION: Obtain assistance! Do not attempt to assemble
the EXM3700GLPS by yourself. Review the Installation
Requirements before proceeding with the following
steps.
The EXM3700GLPS unit comes in seven boxes. Be
careful to assemble components in the sequence
presented in this guide.
NOTE: With so many assembled parts, proper
alignment and adjustment is critical. While
tightening the nuts and bolts, be sure to leave
room for adjustments.
8