Step 14 - Body Solid G9S Assembly Instructions Manual

S T E P
14
Be careful to assemble all components
in the sequence they are presented.
Most of the main frame parts in this step will have BLUE dots.
A. Slide Round End Cap (29) onto Leg Press Handles (BH).
Attach Leg Press Handles (BH) onto Leg Press Frame (BB) using:
Two 71 (3/8"x 3 1/4" hex head bolt)
Four 94 (3/8" washer)
Two 91 (3/8" nylon lock nut)
B. Attach two Seat Pad Flange (BL) to Leg Press Frame (BB) using:
One 70 (3/8"x 3 1/2" hex head bolt)
Two 94 (3/8" washer)
One 91 (3/8" nylon lock nut)
C. Attach Leg Press Seat Pad (BM) to the two Seat Pad Flange (BL) using:
Two 83 (5/16"x 1" hex head bolt)*
Two 96 (5/16" spring lock washer)
Two 95 (5/16" washer)
*Do NOT over-tighten these bolts. Tighten these bolts until spring lock washer is flat.
Over - tightening these bolts will cause T - nuts in pads to strip out.
D. Attach Leg Press Seat Pad (BM) to Leg Press Frame (BB) using:
One 81 (5/16"x 3 1/4" hex head bolt)*
One 96 (5/16" spring lock washer)
One 95 (5/16" washer)
*Do NOT over-tighten this bolt. Tighten this bolt until spring lock washer is flat.
Over - tightening this bolt will cause T - nut in pad to strip out.
E. Slide Plastic Bushing (23) into Leg Press Frame (BB).
Slide Leg Press Back Pad Frame (BP) into Plastic Bushing (23) and hold in place with
T-Shaped Pop Pin (48).
Attach End Cap (14) to the bottom of Leg Press Back Pad Frame (BP).
F. Attach Leg Press Back Pad (BQ) to Leg Press Back Pad Frame (BP) using:
Four 83 (5/16"x 1" hex head bolt)*
Four 96 (5/16" spring lock washer)
Four 95 (5/16" washer)
*Do NOT over-tighten these bolts. Tighten these bolts until spring lock washer is flat.
Over - tightening these bolts will cause T - nuts in pads to strip out.
Note:
You should now wrench tighten all bolts and nuts in this step.
Do NOT re-tighten any of the pad bolts or pulley bolts.
mm
Inch
36