Step 8 - Body Solid G9S Assembly Instructions Manual

S T E P
8
Be careful to assemble all components
in the sequence they are presented.
Most of the main frame parts in this step will have RED dots.
NOTE:
You will need to loosen two Allen Screws (88) inside Seated Press Arm
Support (AA), in order to remove shaft (AB).
A. Attach Seated Press Arm Support (AA) to Top Main Frame (G) with Shaft (AB).
Tighten Allen Screw (88) in Seated Press Arm Support (AA).
B. Attach two Pulleys (26) to Seated Press Arm Support (AA) using:
Two 76 (3/8"x 1 3/4" hex head bolt)
Four 94 (3/8" washer)
Two 91 (3/8" nylon lock nut)
NOTE:
You will need to loosen two Allen Screws (88), inside Seated Press Arm (AC), in
order to remove shaft (AD).
C. Attach Seated Press Arm (AC) to Seated Press Arm Support (AA) with Shaft (AD).
Tighten two Allen Screws (88) in Seated Press Arm Support (AA) and in Seated
Press Arm (AC).
D. Attach two End Caps (14) to the top of Seated Press Arm Support (AA).
Attach two End Caps (15) to the top of Seated Press Arm (AC).
E. Attach Small Shroud (AE) to Seated Press Arm Support (AA) using:
Four 86 (5/16" x 9/16" round allen head)
Four 97 ( 5/16" washer)
Note:
You should now wrench tighten all bolts and nuts in this step.
Do NOT re-tighten any of the pad bolts or pulley bolts.
mm
Inch
24