Step 4 - Body Solid G9S Assembly Instructions Manual

S T E P
4
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 5.
A. Attach Top Pulley Frame (K) to Top Main Frame (G) and Front Vertical Frame (F) as shown using:
One 61 (1/2"x 5 1/4" hex head bolt)
One 62 (1/2"x 5" hex head bolt)
Four 93 (1/2" washer)
Two 90 (1/2" nylon lock nut)
B. Slide the four Shaft Collars (22) to the top of the four Guide Rods (J).
Insert the top of the Shaft Collars (22) into Top Pulley Frame (K).
Tighten the allen screw in each Shaft Collars (22).
C. Insert two Pulleys (26) into Front Vertical Frame (F) as shown using:
Four 10 (pulley spacer)
Two 73 (3/8"x 2 3/4" hex head bolt)
Two 91 (3/8" nylon lock nut)
D. Insert two Pulleys (26) into Top Pulley Frame (K) using:
Two 76 (3/8"x 1 3/4" hex head bolt)
Four 94 (3/8" washer)
Two 91 (3/8" nylon lock nut)
E. Insert two Pulleys (26) into the pulley covers on the Top Main Frame (G) using:
Two 76 (3/8"x 1 3/4" hex head bolt)
Four 94 (3/8" washer)
Two 91 (3/8" nylon lock nut)
mm
Inch
16