Step 2 - Body Solid G9S Assembly Instructions Manual

S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 5.
A. Attach one Pulley (26) to Main Base Frame (A) and two Pulleys to Side Base Frame (B) as
shown using:
Three 76 (3/8"x 1 3/4" hex head bolt)
Six 94 (3/8" washer)
Three 91 (3/8" nylon lock nut)
B. Attach one Pulley (26) and Pulley Cable Guide (7) to the middle of the Main Base Frame (A)
as shown using
One 76 (3/8"x 1 3/4" hex head bolt)
Two 94 (3/8" washer)
One 91 (3/8" nylon lock nut)
C. Attach Front Vertical Frame (F) to Main Base Frame (A) as shown using:
Two 64 (1/2"x 3 1/4" hex head bolt)
Four 93 (1/2" washer)
Two 90 (1/2" nylon lock nut)
D. Attach Top Main Frame (G) to Front Vertical Frame (F) as shown using only one bolt:
One 62 (1/2"x 5" hex head bolt)
Two 93 (1/2" washer)
One 90 (1/2" nylon lock nut)
E. Attach Top Main Frame (G) and Pec Dec Frame (H) to Rear Vertical Frame (E) using:
One 65 (1/2"x 3" hex head bolt)*
One 64 (1/2"x 3 1/4" hex head bolt)
Three 93 (1/2" washer)
One 90 (1/2"nylon lock nut)
*NOTE:
The top bolt (65) goes into an internally threaded nut inside the Top Main Frame (G).
mm
Inch
12