Step 15 - Body Solid G9S Assembly Instructions Manual

S T E P
15
Be careful to assemble all components
in the sequence they are presented.
NOTE:
All pulleys are the 4 1/4" diameter Pulleys (26), except where noted.
Ball Stop End
A. Start at the front of the gym. Insert metal ball end of the Lat Pulldown Cable (36) into Top
Main Frame (G), through the frame and out through the second opening. Pull entire length
of Cable (36) all the way through. Install Pulley (A1) into the first opening, and Pulley (A2)
into the second opening. Be sure that Cable (36) rides on top of these pulleys. Install each
pulley using:
One 73 (3/8"x 2 3/4" hex head bolt)
Two 10 (pulley spacer)
One 91 (3/8" nylon lock nut)
B. Remove Pulley (A3), route Cable (36) inside pulley housing as shown, and re-install
Pulley (A3).
C. Remove Pulley (A4), route Cable (36) around Pulley (A4) as shown, and re-install Pulley (A4).
D. Remove Pulley (A5), route Cable (36) inside pulley housing as shown, and reinstall
Pulley (A5).
E. Route Cable (36) over Pulley (A6). Route Cable (36) down through opening in the small arm
sticking out of the Front Vertical Frame (F). Pull entire length of Cable (36) through.
F. Route Cable (36) throught the Double Pulley Holder (130) as shown and install Pulley (A7)
using:
One 76 (3/8"x 1 3/4" hex head bolt)
Two 94 (3/8" washer)
One 91 (3/8" nylon lock nut)
G. Route Cable (36) up and over Pulley (A8)* and then down toward weight stack.
*Note:
Leave the bolt going through Pulley (A8) hand tight until the end of Cable
Adjustments in Step 21.
H. Remove Bolt (56) from Selector Rod Top Bolt (52), slide Cable (36) through Selector Rod Top
Bolt (52). Attach Cable End Shaft (135) and tighten Allen Screw (136).
Pull Cable (36) tight, so Cable End Shaft (135) fits inside Selector Rod Top Bolt (52).
Reinstall Bolt (56) in Selector Rod Top Bolt (52).
mm
Inch
Lat Pulldown Cable (36)
3840 mm
38
Metal Ball End
12' 6"