Step 11 - Body Solid G9S Assembly Instructions Manual

S T E P
11
Be careful to assemble all components
in the sequence they are presented.
A. Attach two End Caps (13) to the ends of the Low Pulley Frame (AY). Connect Low Pulley
Frame (AY) to the Main Base Frame (A) using:
One 98 (3/8" washer)
One 87 (3/8" x 5/8" round allen head)
B. Attach Foot Brace (AZ) to the open side of Rear Base Frame (D) using:
One 73 (3/8"x 2 3/4" hex head bolt)
Two 94 (3/8" washer)
One 91 (3/8" nylon lock nut)
C. Attach two End Caps (16) and Grip Tape (33) to Foot Brace (AZ) as shown.
D. Attach Pulley (26) to Low Pulley Frame (AY) using:
One 76 (3/8"x 1 3/4" hex head bolt)
Two 94 (3/8" washer)
One 91 (3/8" nylon lock nut)
Note:
You should now wrench tighten all bolts and nuts in this step.
Do NOT re-tighten any of the pad bolts or pulley bolts.
mm
Inch
30