Cisco Catalyst Blade Switch 3130 Reference Manual page 398

service password-recovery
Note If you use the no service password-recovery command to control end user access to passwords, we
recommend that you save a copy of the config file in a location away from the switch in case the end user
uses the password recovery procedure and sets the system back to default values. Do not keep a backup
copy of the config file on the switch.
If the switch is operating in VTP transparent mode, we recommend that you also save a copy of the
vlan.dat file in a location away from the switch.
When you enter the service password-recovery or no service password-recovery command on the
stack master, it is propagated throughout the stack and applied to all switches in the stack.
You can verify if password recovery is enabled or disabled by entering the show version privileged
EXEC command.
Examples
This example shows how to disable password recovery on a switch or switch stack so that a user can only
reset a password by agreeing to return to the default configuration.
Switch(config)# no service-password recovery
Switch(config)# exit
Related Commands Command
show version
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
2-370
Chapter 2 Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
Description
Displays version information for the hardware and firmware.
OL-13271-01