Debug Monitor - Cisco Catalyst Blade Switch 3130 Reference Manual

debug monitor

debug monitor
Use the debug monitor privileged EXEC command to enable debugging of the Switched Port Analyzer
(SPAN) feature. Use the no form of this command to disable debugging.
Syntax Description
all
errors
idb-update
info
list
notifications
platform
requests
snmp
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug monitor command is the same as the no debug monitor command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
show monitor
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
B-20
debug monitor {all | errors | idb-update | info | list | notifications | platform | requests | snmp}
no debug monitor {all | errors | idb-update | info | list | notifications | platform | requests | snmp}
Display all SPAN debug messages.
Display detailed SPAN error debug messages.
Display SPAN interface description block (IDB) update-trace debug messages.
Display SPAN informational-tracing debug messages.
Display SPAN port and VLAN-list tracing debug messages.
Display SPAN notification debug messages.
Display SPAN platform-tracing debug messages.
Display SPAN request debug messages.
Display SPAN and Simple Network Management Protocol (SNMP) tracing
debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays information about all SPAN and remote SPAN (RSPAN) sessions
on the switch.
Appendix B Cisco Catalyst Blade Switch 3130 for Dell Debug Commands
OL-13271-01